It's hard to estimate since you can only tell after engine has been taken apart, depending on crankshaft and other component's wear.
Well if the main bearings need to be replaced What do you think the connecting rod & cam bearings , look like ?? These 3 components depend on good oil pressure to assure long engine life
How much to replace main engine bearings on a Jeep Wrangler 2010
2010 Jeep Wrangler Sport 4WD
-
Maintenance & Repair
The con rod bearings r stuffed due to lack of oil, i have been advised to get it reconditioned but i wanna know if i can just buy a reconditioned engine (which may be cheaper) and just install it......
2011 Jeep Wrangler Sport 4WD
-
Maintenance & Repair
I have a 2010 Jeep Wrangler Unlimited. I took it into the shop for a small radiator leak and they told me The radiator has a hole in it and had to be replaced also the head gaskets were leaking. T...
2010 Jeep Wrangler Unlimited Islander 4WD
-
Maintenance & Repair
What is the most likely cause of an overhearting engine if the expansion tank and thermostat have already been replaced?
2009 Jeep Wrangler X-S 4WD
-
Maintenance & Repair
94 Jeep 4 cylinder yj. I get check engine light after driving a while - stays on till I shut engine off. When I start up again, it stays off for about 5 minutes then on again. Mechanic says he chec...
1994 Jeep Wrangler S
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.