I have a 2011 Chevy Aveo and had to replace all 3 major clutch components, I still can't get it into gear. someone help please.
Asked by April Apr 30, 2015 at 08:22 AM about the 2011 Chevrolet Aveo 1LT Sedan FWD
Question type: Maintenance & Repair
Clutch went out, I replaced the clutch master cylinder, the slave drive, and dropped the
trans and replaced plate and through out bearings. I bled the system and I still can't get it
into gear. Any suggestions?
3 Answers
Did you ever play with the clutch adjustment under the dash when you had the old system in? Try bleeding the system one more time. You may have to adjust the clutch. If you did adjust it, you may have made the stroke too long or too short. Get some help and watch the slave cylinder to see if it's working properly. I have heard of them being defective. Post back with results. I'm hoping it's external and not something like the wedge that holds the throw out bearing falling out of place.
I finally found out what the cause was and it was the pin in the master clutch behind the clutch pedal. Just needed to be adjusted.
It says this is a place for Answer . But u acculy have a Question : - I have a 2011 Chevy Aveo hatch back And i have No Problem shifting Gears but it seems to Me that I'm feeling it slip some not all the time , like in the lower Gears 1-2nd and Sometimes 3 rd never 4-5 5th. I am retired and don't have much $ To just be Spending on new Clutch if it's not the True problem , but i want to stay on top of things so they don't turn into big PROBLEMS I stay on top of Maintenance so any info or suggestions will be Appreciated Greatlly . No Clutch Fluid leaking , Please HELP DONT WANT TO REPLACE A $500 clutch if I can adjust , any Help Please ?? Thanks.
