2007 Jeep Liberty turn and flasher not blinking
Asked by terrygilmore Feb 09, 2015 at 01:58 PM about the 2007 Jeep Liberty Limited 4WD
Question type: Maintenance & Repair
My left turn blinker stopped in middle of a turn. now there is no blinker left or right nor warning flasher. Normally there is a "flasher relay" but auto parts stores and dealership say there is no such part listed in manuals. Dealership says possible fuse, bad ground, or swithch, none of what makes sense to a old mechanic like myselt. Have flasher relays been eliminated in new electronic systems??
3 Answers
Your vehicle has a combination flasher that is part of the hazard switch here is the shop manual for description and testing DESCRIPTION the combination flasher is integral to the hazard switch unit located behind the hazard switch button (1) near the center of the instrument panel. The combination flasher is a smart relay that functions as both the turn signal system and the hazard warning system flasher. The combination flasher contains active electronic Integrated Circuitry (IC) elements. This flasher is designed to handle the current flow requirements of the factory-installed lighting. If supplemental lighting is added to the turn signal lamp circuits, such as when towing a trailer with lights, the combination flasher will automatically try to compensate to keep the flash rate the same. The combination flasher cannot be repaired or adjusted and, if ineffective or damaged, the hazard switch unit must be replaced.
sorryI couldn't copy the wiring diagram but there are two fuses #s 11 and 39
pull cover in front of driver tire twist remove bulb and housing cut black wire connect six inches of wire splice to the cut black wires add a connector and self tap a screw to frame walla renewed ground replace all and done check bulb first of course yer welcome 4 years old but may help someone
