My mustang is having some electrical issues I’m not sure about. All the electronics run fine under 3000rpms but as soon as you pass 3000 all the electronics die including fog lights and speedometer

My mustang is having some electrical issues I’m not sure about. All the electronics run fine under 3000rpms but as soon as you pass 3000 all the electronics die including fog lights and speedometer 1 Answer

While charging my 1966 mustang, I went to start the car and all electrical went dead. No power at all. 7 Answers

The battery is new. The car just sat through winter and I did not disconnect battery. Now there is no electrical power at all. The car has a 289

I'm trying to fix the heater in my 1966 Ford Mustang, and I read in an answer on here concerning the switches for the heater "Also all 3 of those control levers are hooked to cables. Look under the dash and check to make sure those cables are connected and not broken. Sometimes they stiffen up and break." If one of these (the one reading "heat") were broken, would it stop the heater from starting even though all the other parts are working? And if so, what solution is there to reaffix the switch to its respective cable? 1 Answer

Attempting to fix a 1966 Ford Mustang's heater. One of the switches inside of the car is disconnected from its cable, which has broken. What's the fix?

my 2002 ford convertible mustang is having issues ithought it was the battery i changed battery and it will only run for a few minutes and shut off 2 Answers

about 1 month prior i had factory radio taken out and a cd kenwood cd player put in about 3 weeks ago it was really hot outside and it seemed to be running hot i had drips of fluid falling on my fee...

2002 ford mustang coup. My signal lights don't work at all. We replaced all the lights and replaced both relays. No trouble with flashers. Any suggestions what else it could be? 3 Answers

2002 ford mustang coup. My signal lights don't work at all. We have replaced all the lights and both relays. Any other suggestions what could be wrong?