does a new alternator need to be flashed or can I just install and be done
Asked by frankoshea Apr 02, 2017 at 09:21 PM about the 1999 Dodge Dakota SLT 4WD
Question type: Maintenance & Repair
I just bought this truck and they just installed a new alternator but then pcm burnt out with the asd pin still stuck in one of the grey connectors . should I just replace the wiring harness going to the pcm ?. I don't want it to happen to the new pcm i'm buying
3 Answers
You can't get the pin out of the connector? If not you could solder in a new connector. I'm pretty sure they make them.
frankoshea answered 7 years ago
I got the pin out of the connector but should I replace connector or can I reuse it with not problems with new pcm ?
If it's clean and tight you probably can but to answer your "Flashing" question .. No ,,, because flashing was only done on the old generators , not on an alternator Geez ,, that question brought back memories