I have a 1985 ford bronco xlt i went start it this morning and felt like something broke would not roll overwith ignition. Started it by cylanoid but will not come out of park to go in drive how t Fix

Asked by Christopher09 Jan 22, 2014 at 05:05 PM about the 1985 Ford Bronco XLT 4WD

Question type: Maintenance & Repair

I put a new ignition still wont start or come out of park.
Please give me advice with this on how to fix!!!

44,995

tuff4x4 answered 10 years ago

There is a dog leg/actuator between the key switch and ignition switch made out of pop metal. These break and the steering wheel has to come off,turn signal switch and tilt to get to it and the gears inside have to be timed to start right too. You may be better off to just replace the steering column from a junk yard.

Mark helpful

Your Answer:

I have a 1985 ford bronco xlt i went start it this morning and felt like something broke would not roll overwith ignition. Started it by cylanoid but will not come out of park to go in drive how t Fix 1 Answer

I put a new ignition still wont start or come out of park. Please give me advice with this on how to fix!!!

1985 Ford Bronco XLT 4WD

-

Maintenance & Repair
i have a 1985 bronco ii and when i start it it makes a grinding noise just when i go to start it. when it runs it is fine. We pulled the starter and checked the flywheel and you can see where it is nicked but im not missing any teeth. the starter had shavings in it. Replaced the starter once it was fine for the first couple starts then sttarted grinding again. any sugjestions? 3 Answers

1985 bronco ii. 5-speed, 4x4, half year so some parts are 1984 and some are 1985.

1985 Ford Bronco

-

Maintenance & Repair
My 1987 ford bronco 2 is having problems running while cold. especially if I drive for a few minutes and then shut it off. I come back out of the store or whatever and it acts like it's being flooded out. It sputters and dies horribly. It's the 2.9 liter v6. Once it is fully warmed up it runs great 1 Answer

dies when cold. acts like it's being flooded out when only partially warmed up and runs fine when it is fully warmed up.

1987 Ford Bronco STD 4WD

-

Maintenance & Repair
1983 ford bronco xlt 4wd 460 v8 ,I start the engine the fuel pump is steel runing it dos not turn off untiel i turnoff key 1 Answer

when i gt in car turn on key engine runs fuel pump runs well not turn off wild engine is runing

1983 Ford Bronco STD 4WD

-

Maintenance & Repair
I have a 91 ford bronco that takes forever to shift into rev and drive when started 2 Answers

So when we start the bronco in the morning it starts up just fine, but then it takes nearly a minute before it'll shift into reverse, and even longer to shift into drive. like, you put it in reverse...

1991 Ford Bronco Custom 4WD

-

Maintenance & Repair

Used Ford F-150

309 Great Deals out of 13,933 listings starting at $1,712

Used Toyota 4Runner

19 Great Deals out of 300 listings starting at $10,800

Used Ford Mustang

58 Great Deals out of 1,366 listings starting at $4,995

Used Toyota Land Cruiser

125 listings starting at $27,999

Used Ford Ranger

26 Great Deals out of 1,602 listings starting at $3,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have a 1985 ford bronco xlt i went start it this morning and felt like something broke would not roll overwith ignition. Started it by cylanoid but will not come out of park to go in drive how t Fix

1 Answer

Your Answer:

Shortcuts

Search Ford Bronco Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I have a 1985 ford bronco xlt i went start it this morning and felt like something broke would not roll overwith ignition. Started it by cylanoid but will not come out of park to go in drive how t Fix

1 Answer

Your Answer:

Related Questions