Power windows
Asked by Ripmacho Mar 07, 2017 at 07:15 PM about the 2008 Ford Crown Victoria Police Interceptor
Question type: Maintenance & Repair
All of my windows will not work roll down but my
locks work don't know where start to looking at it
checked the fuses and relays they was all good
what should I do next
11 Answers
Check for broken wires between the door and the door jam. This is where they break by opening and closing the door.
I'm having this same issue along with the radio not working, all fuses are good
Same here, no radio or windows but my fuses and relays are fine.
I'm having the same problem with my windows. I ordered a new relay switch that was $70.00 from rock auto so we'll see if it's a fix or not.
Also having an issue with no windows or radio... Anyone figure out a fix?
Fordtecparsonsks answered 5 years ago
So dose anyone have a state answer for this problem.???????
Did anyone figure this issue out??
Check fuse 9 under dash. I bet it's blown. Having the same issue on my 2008 cvpi. Fuse 9, 7.5 amp, keeps blowing. Sometimes blows when radio is turned on or turned off. Sometimes works for days, sometimes blows again same day. Replaced with a 10 amp to match radio fuse, and it blew after a week. Seems to be random. Have had aftermarket radio for 3 years, and this heath started. Checked wiring behind the radio, nothing is frayed or pinched. Next I will try swapping in the factory radio to see if it keeps blowing in case aftermarket unit has gone bad. I feel like I might need to trace the wires through the harnesses to each window button looking for a short. This is going to be a nightmare.
Waltersn337 answered 3 years ago
Spriz is correct my 7.5 fuse was blown and I put a new one in and the windows work, I have been trying to diagnose the problem ever since I probably got the car and its been 2-3 months without the windows working so I’ll see if it keeps blowing or if it was just the one time
Guru9W8GZH answered 3 years ago
I’m havin the same issue but I ran a hot wire from my battery to the radio and it’s working perfectly just the windows isn’t going up they were working before I ran the Hotwire.Found a tracker that the dealer left on it I burned it off radio stopped working I rewired the tracker back up radio came on now the windows aren’t going up
I plug something in my PowerPoint and now my windows don’t work but all my fuses look good