If you mean tighten the cable slack it's best done at the back wheeels. There is a place to take up tension under the console but you should tighten at the back wheels.
The only way I have done it in the past was behind the handle with a 10mm wrench be careful not to tighten it too much though.
Further details on your question or topic
2002 Honda Accord SE
-
Maintenance & Repair
Also purchased a used master switch, and ended up with the same result. The motor is good and the window goes up/down with the left rear window switch... (tried to use a used wire harness and...
2003 Honda Accord DX
-
Maintenance & Repair
Would it be best to take it back to the dealer to get it repaired?
2007 Honda Accord SE V6
-
Maintenance & Repair
I have an Accord 2002 SE Coupe. The engines runs well; but the AC is not cold enough. I need advice on improvements. It it the compressor or the Freon or something else.
2002 Honda Accord SE
-
Maintenance & Repair
1988 honda accord lx carburated 5 speed
1988 Honda Accord LX Sedan
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.