Slip light, VDC Off light, Check engine light on

NISSAN 3.5 V6 CodesTest the CPS 1.black wire 2.orange wire 3.pink... In green connector unplug it use a multimeter and check resistance between these pins right to left 3 2 1 measure the resistance between these pins and make sure that every single combination returns a value. NONE of these pins can return a 0. You could just replace the CPS, I like testing them its simple. Service the CPS and say bye to the other codes! Regards

This just happened to me a month ago and got camshaft sensor replaced.

Have u fixed ur problem?

What was the problem I have the same exact same problem what do I do to fix it

what was the problem? im having the same issues

what was the problem? im having the same proble

It was the camshaft position sensor

My 03 g is doing theu same prob I'll advise anyone to chexk bank 1 2 sensors those are more than likely the prob first time i replaced car never shut odf but now it does it 2-3 xs a day...yess i used after marker sensors and replaced them myself its not difficult a lil tight to get but easy and it will save u 300$ @some mechanic ...my brake fluid is low and a few post talks about that so ima top off fluid first then go from there to sensors if need be...hope this helps someone good luck .....peace

had the same issue as well lil over 6 monthes ago , i replaced the camshaft sensor bank 2 as it said and the maf sensor and drove fine (also bought cheap parts online hopefully it drives fine after sitting so long ) have had it sit for 3 mothes replacing all bushings ,ball joints ,lower contol arm and rear struts . just been lazy

2006 Infinity ..Slip and VDC light went on car turned off..Waited then turned back on..What can it be

I recently replaced the crankshaft shaft sensor to resolve this issue. (Code P0335)

I have the same problem with the nissan fuga 2007, VDC OFF and SLIP (Indicator) lit without going out, the vehicle does not start any more, what should I do? Do you think the problem is related to the camshaft sensors? Hello !

Def sounds like camshaft sensors to me.

I replace my camshaft position sensor, oxygen sensors. Hoses. Heater hose connectors. Coolant reservoirs the fuel pump ignition coils and spark plugs n it’s still doing the VDC, SLIP, SERVICE ENGINE SOON

VDC, SLIP,and Check Engine Soon lights are all on when I crank my 2005 G35 coupe. If I disconnect the battery, everything resets but the same problem on a restart. I've changed the crankshaft sensor, both camshaft sensors, both O2 sensors, new battery, new starter, and cleaned the mass airflow sensor. Still getting getting the same lights. WTF !!!!