After wiring harness replacement

Asked by Guru95JSHQ Jan 21, 2021 at 11:59 AM about the 2000 Oldsmobile Alero GLS

Question type: Maintenance & Repair

I have a 2000 alero. I had to replace the main fuse box and wiring harness
back to the two cabin fuse panels. Now when I turn the ignition to the on
position. I don't hear the fuel pump kick in. Do I have to leave the ignition in
the on position for ten min? Or is the key even chipp?

1 Answer
27,660

oilyspill answered 3 years ago

This is passkey module relearn. I don't know if it will help? with this system, the key doesn't have a pellet or transponder, it's the key cylinder that communicates with security system. It's just a normal key. Did you check for voltage to fuses? Some fuses hot all the time, some go hot with key on. Grounds are all good? I thought passlock was just fuel injector disable. I didn't think it would effect initial prime with fuel pump? good luck

Mark helpful

Your Answer:

Related Questions

  • After wiring harness replacement 1 Answer

    I have a 2000 alero. I had to replace the main fuse box and wiring harness back to the two cabin fuse panels. Now when I turn the ignition to the on position. I don't hear the fuel pump kick in. Do ...

    2000 Oldsmobile Alero GLS

    -

    Maintenance & Repair

  • i have a 2003 alero. after the third fuel pump my car still wont start 1 Answer

    i take the car to the machanic, they always want to put in a fuel pump. i did this three time. after a short period of time the car wont start. plz help

    2003 Oldsmobile Alero GLS

    -

    Maintenance & Repair

  • Radio stays on after I pull the fuse 1 Answer

    Something is draining my battery slowly. The clock on my radio stays on even after I turn it and the car off and close the door. I have to keep opening and closing the door to get it to go off. I p...

    2004 Oldsmobile Alero GL

    -

    Maintenance & Repair

  • My alero wont charge but started after a jump 1 Answer

    The battery is new so is the starter it didn't charge but everything ran after a jump a Lil bit..needs an oil change n lil things like tire pressure other fluids. Nothing working no flashing light...

    2000 Oldsmobile Alero GL

    -

    Maintenance & Repair

  • 2003 Olds Alero 3.4L won't start after changing Fuel Pump & Fuel Filter 6 Answers

    2002 Olds Alero 3.4L won't start after I changed the fuel pump & filter unless I pour a little gas in the throttle body port. Runs fine until I shut it off for a while then I have to ad gas to start...

    2002 Oldsmobile Alero GL Coupe

    -

    Maintenance & Repair

Shortcuts

Search Oldsmobile Alero Questions

CarGurus Experts

  • #1
    TheStern75
    Reputation
    1,010
  • #2
    sun4shine2006
    Reputation
    720
  • #3
    Guru7Q4N
    Reputation
    590
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.