Are the tail light circuit boards assemblies interchangeable? Can you simply plug up one hole and drill another so the pin passes through on the plate?

Asked by vitzky Feb 17, 2014 at 03:15 PM about the 1999 Oldsmobile Silhouette 4 Dr GS Passenger Van

Question type: Maintenance & Repair

Olds silo van....found a drivers side assembly and want to use on passenger side...

vitzky answered 10 years ago

yes they are...just plug the hole for the pin and drill out the adjacent hole so the passenger side pin aligns

Mark helpful

Your Answer:

Are the tail light circuit boards assemblies interchangeable? Can you simply plug up one hole and drill another so the pin passes through on the plate? 1 Answer

Olds silo van....found a drivers side assembly and want to use on passenger side...

1999 Oldsmobile Silhouette 4 Dr GS Passenger Van

-

Maintenance & Repair
can i attach both cars positive and frame when jumping one since the negative terminal is not accessible ? 1 Answer

we own two Oldsmobile silhouettes which i have never jump started before.. the negative terminal of their batteries is buried under stuff and not accessible.. i know when you jump cars normally you at...

2003 Oldsmobile Silhouette 4 Dr GLS Passenger Van Extended

-

Maintenance & Repair
where is the fuse located for a 2003 Oldsmobile Silhouette dashboard and tail lights 4 Answers

I got in the car and I turn the car on in my automatic dashboard lights and the back till like did not come on or the lights to the button for the 30 in the air conditioner does not work but my bra...

Oldsmobile Silhouette

-

Maintenance & Repair
I towed the van in a dolly. Now my AWD light is on saying it's not working. Can I remove the rear driveshaft. I'm sure it not recommend but since it won't kick in the AWD can I remove the shaft 3 Answers

And still drive it? Maybe better MPG? There seams to be a lot of drag on 1rear wheel? Resulted from the toe?!?

2002 Oldsmobile Silhouette 4 Dr Premiere AWD Passenger Van Extended

-

Maintenance & Repair
I have a 2003 Oldsmobile Silhouette and it keeps over heating first problem was it had a hole in a hose so changed it that caused the serpentine belt to snap changed that also took thermostat out for few days didn't stop so replaced with a new one then changed my water pump and I'm still over heating and now it acts like it dont want to start takes forever to start and looses power when I slow down and is still overheating 5 Answers

Changed my thermostat changed my water pump and new serpentine belt and still overheating??? So today were going to change the alternator, but need more information on if I'm right or wrong

2003 Oldsmobile Silhouette 4 Dr GL Passenger Van Extended

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.