Your Answer:
Related Questions
-
i hav a 96 ranger, 2.3 L. for a 1 yr. now it has been in shop several times for same problem & not gettn fixed. my #3 & 4 plug are miss firing at initial start & back fire until it warms up than ok. 1 Answer
1996 Ford Ranger XLT Extended Cab SB
-
Maintenance & Repair
-
I have a 96 Ford ranger, 4 cylinder manual and have a problem I can't figure out. I can start the truck every time with no problem it isles great and I can sit there and rev it all day no problem but if I go to drive it I can make it about 1/2 mile and then that's it, ill press the gas petal and it won't do any thing but kill the gas (no gas) but soon as I take my foot off the gas it will idle just fine and rev fine but won't go anywhere unless I let it sit for a few mins and it will start all over. I have replaced the IAC, TPS and today the external fuel filter that was clogged but same thing. Once in a while if I push the clutch in it will stay at a rev for a sec. Please help 5 Answers
96 Ford ranger need help :(
1996 Ford Ranger XL Standard Cab SB
-
Maintenance & Repair
-
i have a 1990 ford ranger 2.3 liter the 8 spark plug and it will start up fine then i will drive it for about 5 mins and then it will run bad 4 Answers
1990 ford ranger 2.3 liter the 8 spark plug and it will start up fine then i will drive it for about 5 mins and then it will go to spitting and sputtering and backfiring and when you give it gas it ...
1990 Ford Ranger XLT Standard Cab SB
-
Maintenance & Repair
-
I have a 1990 ford ranger 4x4 2.9 liter v6. It had set for a couple years and i got it and i have put everything fuel related on it new! And now i can drive it until it gets warmed up good and it will 6 Answers
It will die on me after its warmed up good and will turn over but wont start but i can let it set for a while and it will start up and do the same thing.(oil pressure hand jumps around) i was thin...
1990 Ford Ranger XLT Standard Cab 4WD LB
-
Maintenance & Repair
-
i have a 1992 ford ranger xlt 2.9L 5sp standard. gears 1-3 are fine. however 4and 5th gear a problem. at 45mph i'll put in to 4th gear and it loses power and shakes/sputters. also in 5th gear. acts like a mis-fire. i changed: plugs/wires, egnition coil, fuel pump/filter/sending unit and fuel pump plug. what's wrong. 5 Answers
why am i losing power, speed, and problems accelerating past 3rd gear?
1992 Ford Ranger
-
Maintenance & Repair
Shortcuts
Search Ford Ranger Questions
CarGurus Experts
-
#1Gene ArnettReputation4,420
-
#2Bob BeamanReputation3,010
-
#3Jennifer GorhamReputation2,620
Find great deals from top-rated dealers
SearchRelated Models For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.