If this has sequential turn signals in the rear then the module could be bad but you need to check for power and grounds to the sequential module. Now if it doesn’t have sequential signals then most likely the turn signal switch has went bad but you should check the 4way switch to make sure it is all the way off, maybe cycle it a few times.
Check the flasher relay. Usually located under the dash.
2013 mustang gt500, rear turn signals and rear flashers not working. Checked fuse 6 & 22 both good. Any ideas
2013 Ford Mustang Shelby GT500 Coupe RWD
-
Maintenance & Repair
2003 ford explorer base model we changed the signal switch also the bulb and socket and wiring not to mention fuse just can't get them to work any help , joan
2003 Ford Explorer XLS V6 4WD
-
Maintenance & Repair
Recently having problems with charging system notification going off in the car, installed new battery, car also gives notification the traction control not working. The red switch under the hood ...
2008 Ford Mustang Shelby GT500 KR Coupe RWD
-
Maintenance & Repair
Replaced bulbs, replaced turn signal switch. My left turn signal will work on occasion, right turn signal works ALL the time. ***Turns off when turned to left signal position. Any ideas on how to ...
2007 Ford Expedition EL Limited 4WD
-
Maintenance & Repair
2013 Shelby with 5000 miles started making a popping noise when backing out of a parking space with wheel turned steep. I believe the brakes are grabbing momentarily and it does it two-four times ...
2013 Ford Mustang Shelby GT500 Convertible RWD
-
Maintenance & Repair
CarGurus has 35 nationwide Mustang Shelby GT500 listings starting at $49,995.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.