I changed rear wheel cylinder on passenger side, when started to bleed the brakes, and when pedal was to floor,,stopped running..will crank and run in 5 minutes..hit brake, dies again....

I changed rear wheel cylinder on passenger side, when started to bleed the brakes, and when pedal was to floor,,stopped running..will crank and run in 5 minutes..hit brake, dies again.... 2 Answers

i have a 1985 bronco ii and when i start it it makes a grinding noise just when i go to start it. when it runs it is fine. We pulled the starter and checked the flywheel and you can see where it is nicked but im not missing any teeth. the starter had shavings in it. Replaced the starter once it was fine for the first couple starts then sttarted grinding again. any sugjestions? 3 Answers

1985 bronco ii. 5-speed, 4x4, half year so some parts are 1984 and some are 1985.

When the negitive is connected to the battery the truck tries to crank with no key in the ignition. What do I need to look at ? 1 Answer

Battery sparks and tries to crank the truck when the negative cable is attached. No key is in the ignition, the truck cranks but doesn't turn over. Starter is 6 months old, it has a new starter soleno...

I have a 91 ford bronco that takes forever to shift into rev and drive when started 2 Answers

So when we start the bronco in the morning it starts up just fine, but then it takes nearly a minute before it'll shift into reverse, and even longer to shift into drive. like, you put it in reverse...

how do I replace a broken U-Joint on the front (4x4) drive shaft and put the now removed drive shaft back in -without going to a mechanic? 1 Answer

I have a 1990 full-size Eddie Bauer Bronco. This is my first 4x4. I put it in 4low and 4high one night and drove at about 3-5mph up my driveway and back,about 60 yds. had a heck of a time getting it o...