Chevrolet C/K 10 Questions Maintenance & Repair
Bad Oil Pressure Gauge Or Bad Oil Pump?
Ive got a 1985 Chevy K10 with a 305 TPI out of an '86 IROC-Z. Truck has 124,XXX miles and the engine has a little less. My oil pressure gauge is usually around 30 PSI but sometimes it'll drop to arou...
My 68 Chevy Truck Wont Trun Over Had Battery Charged Starter Checked N Stil...
battery checked starter checked and still not turning over
Why Does The Starter Fuse Continually Blow?
fuses keep blowing on the starter - seriously, I have replaced about 20
Can't Time My '79 Chevy K-10.
She's got a 350, new plugs/wires, and the plugs are properly gapped. The timing chain is on correctly, firing order is correct, only things I can think of are distributor or cap or a slipped balancer...
Grinding From Somewhere In 4WD On Hills
I've got a 1985 Chevy K10 pickup. I was at a party the other night on my friends farm and needed 4wd to get up a steep hill to leave. When I hit the hill I noticed a winding/grinding coming from unde...
How Much Freon Does A 1969 Chevy C10 Hold?r/134
getting air working again. holds good vacuum. i just need to know how much freon to charge the system with.
Does The Bed On A 1964 C10 Stepside Disassemble In Individual Pieces?
I am removing the bed on my 64 stepside by individual pieces. I have the sides staged for removal. However, the tailgate support or crossmember appears to be one piece or welded to the the bed side. I...
700R4 Automatic Transmission Slips When Shifting From 2nd To 3rd Gear
My transmission began slipping when it switches from 2nd gear to 3rd gear. The truck isnt driven often as I go to college in another state and use another truck as a daily driver. It does have transm...
Can The Engine And Transmission Be Removed Without Removing The Transfer Ca...
I am replacing the motor and servicing the transmission. Do I have to remove the transfer case as well?
I Have A 66 C10 With A 350 With A Radiator Mounted Fan But No Fan Blades On...
just bought this truck and it ran great untill lately it seems when the engine gets to running temp or after about 5 miles or so the engine starts to run and idle ruff any ideas?
My 1971 Chevy C10 Hood Wont Open
I recently had some engine work done on my 1971 chevy truck c10. now the hood wont open. how do I get it opened?
1971 Has No Power At All
replaced the distributor on my 1971 c10 it started right up ran perfect at idle for 30 minutes I shut it off an walked in house to get a drink came back out to start it again and it would not turn ove...
Have 1986 Chev K10 Auto Trans Leaks Bad We Replaced The Seal It Still Leaks...
is it possible the seal didnt get put in right. after we replaced the seal we pulled tranny all the way out, pulled the converter out and it was leaking out the seal in the center part.is that normal
Replacing Tail Lights 1985 Chevrolet Swb
I'm having trouble with my lights. When lights are on my right low beam headlight & right tail & turn signal do not work. But when off turn & brake light. What could be the cause of this. Plus I ...
I Have A 1972 Chev C10 Pickup With Dash Gauge Issues.
The oil/temp/amp gauges in dash do not work. The gas gauge and dash lights do work. I have changed temp sending unit because the needle pegged when grounded but that didnt help. Also the feed wire doe...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.