Chevrolet C/K 10 Questions Maintenance & Repair
Ran My C10 71' Out Of Gas The Other Day And Ever Since It Won't Stay Runnin...
It runs for about 3 mins without me giving it gas then sputters out and dies. Then I have to continue giving it gas to keep it running. I have not touched the timing. It ran prefect before I ran ...
On My 1972 Chevy C10 350 Truck - Can I Replace The Stock Temp Sensor With A...
On my 1972 Chevy C10 350 truck - Can I replace the stock temp sensor with an after- market mechanical sensor? If so, can I use the stock sensor location for the after market unit? With test light th...
79 C10 Hard To Start
its gotten to the point were i had to pour a bit of fuel in the carb to get it start it. if it sits for a day i would have to do the same thing again, so i changed the mechanical fuel pump, primed it ...
Im Looking For A Fuel System Diagram For My 1985 Chevy C10 To Figure Out Ho...
I just bought a new Crate 350 LB 5.7L engine. Went from a stock 305 and now its pretty much all custom. I have a OEM mech fuel pump, but new edelbrock carb wants less than 6psi than the 10psi that t...
Turn Signal Flashes
changed signal switch turn signal flashes
I Have A 1971 C10 With A 3 Speed On The Column. I Can Put The Shifter In Al...
As far as I know the clutch is good. There is no noise or odor that indicates to me the clutch is bad, but I don't know for sure it could be I'm no expert on clutches. How can I know for sure if it ...
I Have A 1971 C10 With A 3 Speed On The Column. I Can Put The Shifter In Al...
I am asking this question again to clarify my first question. My question wasn't clear what I intended to say was that I have to accelerate and increase to a very high RPMs in order for the truck to...
I Have A 1971 C10 Truck. The Motor Sounds Smooth But When I Shift It Into G...
I have just purchased this truck and I know very little of its history. The truck starts easily on the first crank and sounds very smooth when idleing. It has a three speed on the column that shifts...
I Need To Know The Correct Name Of The Part That Is Rotted On My 76 Stepsid...
I would post a picture but cant
Starting / Running Issues 1986 Chevy C-10
Starts right up. drive it for a bit. good. stop somewhere and go to start and it just turns over and over. Go back several hours later and starts right up again. Fuel good. Spark good. Bad ignition sw...
Will A Starter From A 2003 Chevy Silverado 3500 8.1L Fit A 1969 C10 With A ...
I read that some of the newer chevy starters such as the one from a 2003 silverado will fit late model chevys but are better as they are high torque mini starters. GM stayed consistent with the moun...
Brake Peddle Almost Hitting Floor Board
Replaced front brakes on 1968 Chev 1/2 ton pickup. Bled all four lines as peddle was almost hitting floorboard before and fluid was low in master cyl. Still have very low brake peddle. Do I need ...
Gas Primed
have a 1978 chevy cheynne full size pu two wheel drive and 350 engine. Has dual tanks. My problem is when the pu sits for more then 24 hrs I cannot start it without priming the carb. I even have a ...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.