Ford Bronco II Questions Maintenance & Repair
Fuel Pump Or Oil Pump? Bronco2 Help Please
I have an 86 bronco 2, and it has become very sluggish lately, and when it switch gears it idles down like it not get fuel then pics back up. Also my oil pressure gauge drops from 50 down to 0 whe...
Car Shuts Boff After About Half Hour Running.
2.9 bronco2 shuts off after engine warms up? could it be the charcoal tank? does not over heat, fuel filters changed fuel pumps ok, put in new fuel regulator.seems like a vapor lock? put heatsink on d...
I Have Gas Going Into The Oil - Engine.
what should I do when the fuel is getting into the engine. I need to correct this problem
86 Bronco II Wont Start
running great then went to store came out and wouldn't start. changed filter in tank and in line filter, pumps are working, good fuel pressure. new fuel relay, put new spark plugs in the old ones we...
89 Ford Bronco Ii Xlt Won't Start
I have a 89 Ford bronco ii with a 2.9 l v6 I had a blown head gasket so I changed out the gaskets I did everything by the book I bought a Chilton's manual so I knew I wouldn't screw it up I follo...
86 Bronco Ii Goes In Gear Wont Move
when i press the clutch in it goes into every gear bugt when i release the clutch it doesnt move. ive tried pjutting it in 4 wheel drive also and nothing moves. it just makes a clanking noise. i can...
Will The Engine Out Of A 1996 Explorer Fit Into A1989 Bronco 2 With No Prob...
exchanging the 2.9 engine with a1996 explorer
What Causes A Rattle Or Clatter In The Clutch When Not Depressed In Shiftin...
86 Bronco II 5 speed trans. when you push in clutch to shift gears it is normal, but when releasing the clutch there is a rattle or clattering. I don't think there is anything wrong with the throw-o...
I Have A 1985 Bronco II Standard Shift, I Need To Change The ECM. Where Is...
I am trying to change out the Engine Control Module (ECM) where will I find it?
Will My 84 Bronco 2 Tranny Fit In A 92 Ford Ranger?
I have an 84 bronco 2 with a bad engine. It's a v6. 5 speed. 4x4. AND I have a 92 2 wheel drive ranger with a 2.3 liter 4 cylinder. Will the transmission from the Bronco 2 fit into the Ranger...
Have 1988 Ford Bronco 2 2.9 It Runs Good But If U Drive For Awhile It Will ...
has new Icm checked the emec. gas shut off and works fine but do smell gas fumes in my vacuum line on fuel reg not sure if whats wrong
88 Bronco 2 Right Front Door Power Window Regulator Will Not Stay In The Pl...
88 bronco 2 right front power window regulater will not stay in the plastic holder that connects it to the glass hardware. Where can I find a new one or can this one be repaired?
Have 1988 Ford Bronco 2 2.9 It Will Run Then After Few Miles Will Shut Off ...
changed the fuel filter was bad and put cleaner in the tank but drove it about 10miles on the way back it shut off the few mins fired back up
Drive Ability
After driving my b2 for awhile and it gets hot it will lose power like it has a restriction somewhere. I have replaced the catalytic converter, o2 sensor, throttle position sensor, and map sensor.
Not Too Sure What Else To Do, Any Ideas?
It won't start we've adjusted the timing and think we have it timed. There is no compression is one cylinder, and barely any in another. Finally got it to start last night but only for a few second...
EGF
Replaced every thing in the EGF. System and the OBD still points to it as the system problem. No vacuum leak in vac lines. Need help. Thinking new EEV IV is next.
Rear Tail Light Problem
Rear passenger brake light & license plate light goes out when brake is applied
Clutch Adjustment On 1989 Ford Bronco 2
Clutch doesn't contact till almost to the top. Has a new clutch in it
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.