Ford Ranger Questions Maintenance & Repair
Anyone Out There No How To Disable The Daytime Running Lights On A 2010 For...
This Ranger was sent to Quebec for sale and ended here in Michigan where I purchased it. Need to know how to turn off the DRL. Anyone know where the sensor or module is located on this vehicle?
Can I Use A 1995 Ford Explorer Transmission In My 1995 Ford Ranger
I need to replace the transmission in my 1995 Ford ranger and need to know what other years and models have this tranny.
2008 Ford Ranger 4x4 Ext Cab When Turning Left The Dome Light Comes On Turn...
just put on some wd40. like I said I would like to know where that sensor is and can I replace it myself?
99 Ford Ranger Xlt Changed Every Sensor And Relay Known To Man....
Truck will start (when it wants to) in the morning or after sitting for a few minutes. However, in no time at all or 10 miles down the road it looses all power but motor runs and still has oil press...
My 1995 Ford Ranger Runs But Wont Idel
runs but wont idel
95 Ford Rangerki
No brake lights won't shift out of park
WHAT COULD CAUSE SKIPPING, POPPING, AND NO POWER
We have a 1988 Ford Ranger it was loosing water, my husband replaced the water pump, thermostat, radiator, clutch fan, then replaced the head gaskets, and manifold gaskets. Its still loosing some wate...
I Have A 2003 Ranger With A 2.3L. I'm Looking For A Vacuum Hose Diagram.
I just bought this Ranger. I got it cheap because it's running rough. After I got it home I notice that several of the vacuum lines were connected to the wrong locations and a couple others were ...
Shape, But The Power Surges All The Time, Expecially On The Climbs. Any Ide...
I picked up a 04 Ranger in great shape, but the power surges all the time, especially on the climbs. Any recommendations?
My 94 RANGER Recently Stopped Moving. When I Push On The Gas The Engine Re...
1994 ranger 3.0 2 wheel drive.
What Would Make My 93 Ford Ranger Cranck Over And Over And Not Start
I changed the head gaskets and now it won't start
My 1996 Ranger Goes In Gear With No Grinding (all Gears)
my clutch goes to the floor easily with no pressure. It will shift into all gears and no grinding or anything. What is wrong
Is The Shifting Of Gears When The Engine Is Running Accomplished With Grin...
The clutch slave is bad. I think it needs replacing or bleeding. I am concerned that shifting into gear does not prevent the truck from moving. The truck is a 1996 ford ranger.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.