Mazda B-Series Questions Maintenance & Repair

How Do I Remove The Power Streering Belt On A 1992 Mazda B2600i 2.5l

I have a 1992 B2600i and am attempting to replace the Alternator belt but can't figure out how to get the Power Steering belt off... no tensioner pulley and no obvious way to move the Power Steering ...

Repair Manual I Need To Replace The CV Bearing Or Whole Joint.

I need to replace CV bearing but advice from member here that easier the replace the whole joint, Where can I get a repair manual or 1989 Mazda B-Series pickup B2600i 4WD 2 DR SB Cab ??? I really need...

Battery Light On

My battery light is on and my check engine light is flickering on my 1993 Mazda B2600 pickup truck 4X4. Does this mean the alternator is going out?

Will My 1994 Mazda B2300 Pick-up 4cylinder, Run On E 15 Without Problems?

I have only ~166K + on this vehicle, and now there is talk of going from E10 to E15 gasahol. Will this vehicle have problems with this new blend?

How Do I Tighten The Power Steering Belt On My 1991 Mazda Pickup?

I've loosened the tensioner screw but the pulley does not move.

Water Leak In 2000 Mazda B4000 Truck

When water/ rain goes into the outside vent it drips inside the passenger side. It appears to be welded and all metal where the vent is located. People talk of a drain but I cannot see one from the ...

Engine Cuts Out

Runs okay upto about 40 mph then it cuts out. What's going on? Thanks

Engine Bucks Under Load At Low Rpm

I have a 1998 mazda b4000 std transmission,130000 miles,well maintained.the past 3 years,it has bucked if I lug it at low rpms..was fine for the first 5-6 years..bucks with hi octane as well.any clue...

Thermostat

Where is it located under the hood?

B4000 Starts Sometimes, Other Times No Spark

My B4000 has this funky habit of not starting at times. For a while I thought it was when it was hot but now it happens whenever it wants. After some troubleshooting, I have found that when it doesnt ...

Tires

Can I put bigger size tires on the rear?

The Engine Starts To Cut Out At High Rpm After Getting Warmed Up

i own a 1991 mazda b2600i 2.6 lit. 4x4,feul injected,5 spd standerd transmission.after getting warmed up the engine starts to cut out,i will be driving and suddenly ill atempt a take off i press gas p...

1994 Mazda 2WD B Series Pickup Problem With The Heat

how come when i go to turn the heat on high its like its on low. and then when i got to turn it down one it practially shuts off. its like the high is the low.. is there anything i can do?

Where Is The Warning (door Open Etc) Thing, I Need To Eliminate It. It Neve...

1992 Mazda B2600i Extended Cab Will Not Get Fuel Through Injectors

i dropped the gas tank and replaced the fuel pump, but i still do not get fuel through the injectors. it will run all the way through and back to the tank just does not shoot through the injectors. th...

B2600i Extended Cab 5 Speed Manual 4x4

my truck drives fine but all the sudden its like its not getting fuel it keeps bogging out loose all power and the truck starts jerking, any tips on wat to do

CV Bearing, Joints...

I like to know if it's easy to replace CV bearing and joint???

Left Turn Signal Wont Work, Right Does Work. What Is Going On

My left turn signal started intermitantly working and now doesn't at all. the back light lights up but doesnt flash.

1999 Mazda B-3000 4x2 Extende Cab,3.0L W/5spd

I need to know what is involved to remove the oil pan to replace the oil pump. Does the transmission need to come out for clearance in removing the oil pan? thanks to anybody who can advise me.

I Have A 1993 B2200 Mazada Pickup The Engine Light Is On And The Truck Does...

We check the anlternator, distributor, and had the fuel pump changed and the carburator converter changed. Still no avail. We are in the process of changing the computer next.