Mazda MAZDA3 Questions Maintenance & Repair
Mazda 3 '06, Doesn't Turn On
I parked the car in the parking lot of our apt around March. Since then I regularly turned it on (even though not so often). Today though, while I tried to turn it on again, when I turned the keys,...
Roaring Noise When Accelerating
My car makes a strange roaring noise when accelerating, it's a manual and it does it through every gear but does occasionally stop, when it does stop you can hear it again when the car hits a bump ...
Car Doesnt Start No Codes On Or Spark Why?
I have a 2007 Mazda 3 2.3L and when starting the car it'll crank but doesnt start, I've checked the coils and spark plugs with a test nobe test light and there is no spark. Any advise to resolve th...
Mazda3 2.3L Cranks But Doesn't Start With No Codes
Ok smart techs here's one that's not normally asked being a first time Mazda owner I really loved the car inside out and had plans for custom word 100% 2007 Mazda 3 2.3L 2 months ago I I put 4&1/2...
Engine Stalling Cause?
My 2018 Mazda3 has only 18,000 miles. Today I was waiting in a line of cars for 30 minutes, suddenly I tried to press the gas & the car wouldn’t move. My car was on but it was stalling. The batter...
Programming Transmission Control Module?
I’m replacing my transmission control module on my 2008 Mazda 3. Part #L34T-18-89E1E. I was told by the Mazda dealership I’m ordering the part from, it doesn’t need to be programmed, and I’ve also ...
I Replaced Timing Chain It Now And You Don't Start What's The Problem
I replaced my timing chain by the book on my 2007 Mazda 3 2.3 and everything was put back correct but now my engine does not want to start but crank shaft rotates I need some advice please.
2008 Mazda 3 Motor To A 2005 Body 2.3
I recently completed an engine swap of a 2008 mazda 3 2.3 to a 2005 mazda 3 body. I checked all 3 timing components and also checked the fuses and wiring. The motor cranks but will not start. Please...
Is There A Way To DIY A Ruined Logo On A Steering Wheel?
How do I go about fixing or covering the logo with a chrome or silver like paint pen? Or do I have to get it replaced?
How Do I Fix This Scratch On My Bumper And How Much Will It Cost? DIY??
Wondering how to fix this scratch or if it totally needs to be sent to a shop
How To Replace Main Fuse 2008 Mazda 3
Installed battery backwards, now won’t start. Swapped around the starter and main relay with heater relay, still nothing. Main starter fuse is next, which is bolted to the positive terminal. Just ...
2011 Mazda3 Intermittent No Start/no Crank
Intermittently will not start or crank. Lights come on. Will usually start eventually within 15 minutes. No codes. Have tried moving shifter to neutral, passing through gears and back into park or ...
My Tail Lights Won't Work On My 2008 I Have Replaced The Taillights Already...
2008 Mazda 3 tail lights
Mazda 3 Sounds Like It Is Starting And Then Dies. What Wrong?
Out of the blue my Mazda 3 won’t start. I turn the key it sounds like it is starting and then it just dies. It never gets to the point of actually running. At terry seems fine. It cranks and cranks...
Automatic Car Jerking
Mazda axella (Mazda 3) 2.0L 2007 model (automatic) started jerking as I was driving,in fact the jerking happens after the battery light flashes on and off,what should I do?
Will My Battery Recharge Hold ?
If I took my battery into local auto parts store had them tell me a cell was bad but then tried recharging and the battery fully charged, also had them test alternatior and they said it was fine, ...
Is Is The Transmission Or Not?
My son broke his front cv axle, damaged control arm, etc. I raised the front end up and removed the broken cv axle. Then I wanted to check the transmission so while it was still on jacks I started...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.