Mitsubishi Mighty Max Questions Any type

Mitz Mighty Max '95,,the Clutch Is Hard To Push And Its Not Letting The Gea...

also do they make a rear part for the cab,mine is open into the bed ? goodcat60@gmail.com

Clutch Cable

put new tranny in would nt go in gear running put new clutch cable cant adjust it old one had some tension on is could washers help old one?

Timing Marksfor1993mitsubishi Mighty Max 2.4L

how do i set the timing marks for a 1993 misubishi mighty max trk.2.4L

Torque Value For Transmission Pan Bolts

changing the tranny fluid and i need the torque value for the transmission pan bolts.

Does Anybody Know Where I Can Get The Tubing For Water Pump

My mechanic tried to replaced the water pump with a new one but found that the "tubing" that connects to the water pump has deteriorated so water is leaking. Does anybody know where we can get that pa...

When Removing To Timing Cover Does The Bottom Pully Have To Come Off First ...

i have tooken all the bolt or nuts on the timming cover still can not remove it to get to water pump. I do not understand why they made it where the timming cover is behind the pully where you can n...

94 Backfiring In The Intake

I have a 94 Mighty Max and it just started backfiring into the intake at lower rpm's. it doesnt do this at higher rpm's. It will be a low level backfire in the intake and I will lose power momentaraly...

Cutting Out Problems

i have a '88 mighty max sport and it starts to cut out between 2 and 3 grand shifting from third to fourth gear. Does anyone have any ideas on what it could be.

Std/Max Payload

The GAWR for the rear axle says 2450 lbs. Can the truck really hold 1ton in the back of the truck

Hard Starting On My 1991 Mitsubishi Truck 5 Speed Manual

1) Sometimes when I start my truck and it misses the first time, I smell gas and it won't start for a little while then I would wait for about 5-10 minutes to start again and will usually start. Th...

5 Speed Transmissions

no one can correct my problem. clutch cable has broke at least 5 times and the plate that holds the gear shifter in place has come loose 3 or 4 times. trans has been rebuilt...cltch has been replace. ...

Why It Was Stopped The Manufacturing Of Pickup Truck In Usa

Where Does The Wire Go?

First I started blowing the MFI Buss fuse that is attached to the battery, I had sparks coming out of the housing that holds the throttle cable, figured short/grounding problem. cleaned up all grounds...

Is It Hard To Install A Oil Pump On A 2.4 Engine

need to fine a oil pump, and install it myself

How Can I Check Water Pump To Make Sure It's Ok

removed and gutted old stat and reinstalled but left radiator hose off stat housing but still connected to top of radiator. duck taped a garden hose into loose hose and turned water on. water flew thr...