Electronic Ignition

Asked by 1970Dodge Aug 29, 2009 at 02:44 PM about the 1970 Dodge Dart

Question type: Maintenance & Repair

I just converted my dart to an electronic ignition but i am having a bit of a problem. after the engine is started i noticed that my starter keeps running. I found out that if I disconnect a wire after the engine is running my starter will stop running, and the motor will run great. the wire that I disconnected is the new wire that is connecting the coil and the balist resistor, and it is the wire that also needs to be connected to the start wire.  Any ideas because im tapped out.

1 Answer

10

Does it have a starter relay switch on the firewall or fenderwell?? Make sure you don't have your wires switched..the keyswitch wire on the starter make sure it's on the right side of the starter..if it has two wires..switch them..see what happens

1 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Joshf123456
    Reputation
    1,140
  • #2
    Humpty Dumpty
    Reputation
    960
  • #3
    Melisa4romTx
    Reputation
    490
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Dodge Charger
28 Great Deals out of 816 listings starting at $6,200
Used Dodge Challenger
15 Great Deals out of 329 listings starting at $11,999
Used Chevrolet Malibu
35 Great Deals out of 918 listings starting at $1,800
Used Toyota Corolla
149 Great Deals out of 2,225 listings starting at $2,595

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.