1998 buick lesabre changed ignition lock, and ignition module. still wont start. security light
1998 buick lesabre changed ignition lock, and ignition module. still wont start.
security light
TheStern75 answered 7 years ago
This is a very common problem on GM vehicles. The security system is known to fail. Basically when you insert your key, the system checks for certain OHMS resistance. If the system cannot get the correct signal from the key, it assumes the key is incorrect and goes into SECURITY lockout mode. (prevents hotwiring) This has been happening with GM;s for a very long time. There are ways to bypass this now. Read through this page for info, solutions as well. http://www.diy-gm-security.com/
1998 buick lesabre changed ignition lock, and ignition module. still wont start. security light
Buick LeSabre
-
Maintenance & Repair
I have had a 97 and 98 LeSabre that have the fuel pumps replaced every 3 to 5 months. My mechanic has no idea what to do about it. Does anyone know what is going on?
1998 Buick LeSabre Limited Sedan FWD
-
Maintenance & Repair
brand new battery and starter recently tuned up as well when I go to put the key in the ignition if my door is open it dings as if my battery is good, lights come on dash lights come on. but when I ...
1978 Buick LeSabre
-
Maintenance & Repair
My 2002 Buick LeSabre idle fluctuates and dies when coming to a stop. I have changed the air/idle control valve, the MAP sensor and the MAF sensor was changed recently also but the problem still exist...
2002 Buick LeSabre
-
Maintenance & Repair
2005 Buick LeSabre, runs rough, check engine light on. No spark for 1 and 4. Changed coil, still no spark.
2005 Buick LeSabre Limited Sedan FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.