i have a bent rod can i change my rods by taking the rockers off or do i have to tear the whole engine apart?

i have a bent rod can i change my rods by taking the rockers off or do i have to tear the whole engine apart? 4 Answers

My Dodge diesel 6.7 was running good and when I came home from work, shut off and 2 hours later I went to start and the engine turns over, but will not start. I thought it was a fuel problem, so loosen injector and turned over and had fuel. I tried to run engine analyses and nothing. It appears there the electrical has shut down, but the engine still turns over. Are the fuel injectors electrically pulsed or by pressure form pump? The only thing that come up is check gauges. No engine light at all. 2 Answers

Turned truck off and about 2 hours later, tried to start and the engine turned over, but would not fire up. I checked to make sure it had fuel at the injectors and it did. Are the injectors controll...

Do I really need/have to unhook the A/C system to replace the leaking heater core ? 2 Answers

Is it absolutely necessary to have the air conditioner evacuated to remove & replace the heater core ? There must be a way to go 'around' this requirement . Gurus ?

i have no ground power to my sending unit 1 Answer

i have no power to the ground side of my sending unit i only have power to two wires an the other two nothing threw postitive or the nevtive way of a test on a wire test so where do i start sorry so...

I have a 2006 2500 Dodge Ram diesel and I can't get out of park. Already replaced the line from the shifter to the tranny and still can't get it to change gears. someone told me there is a brake sensor that allows you to change the gears where is it located 1 Answer

my truck wont come out of park. No tranny problems before last weekend. Changed the cable from the shifter to the tranny cause I broke it and still truck can't change gears. Please help