Car starts fine, but when put in drive or reverse the car won't move and when I press the gas a screeching noise will come and will jerk

Asked by Uriel May 10, 2017 at 02:15 PM about the 1990 Toyota Corolla Base

Question type: Maintenance & Repair

The other day I was driving when I heard a
humming noise that would not stop from the
freeway to my house. The next day I tried to drive it
but when I put it in drive or reverse it would barely
move and start screeching. I've refilled the
transmission fluid because it was low and it still has
this problem. I'm not sure what's happening

Uriel answered 7 years ago

Note: I don't have a check engine light on and the exhaust is leaking small amounts of fluid.

2 people found this helpful.

Mark helpful

Your Answer:

Car starts fine, but when put in drive or reverse the car won't move and when I press the gas a screeching noise will come and will jerk 1 Answer

The other day I was driving when I heard a humming noise that would not stop from the freeway to my house. The next day I tried to drive it but when I put it in drive or reverse it would barely mo...

1990 Toyota Corolla Base

-

Maintenance & Repair
I have a Toyota corolla 2003 s ..my car vibrates real hard when i put it on reverse and when i stop and on idle..but it doesnt vibrate in neutral gear..what is the problem pls 4 Answers

My vehicle vibrates when on reverse gear..it vibrates when i stop of press break on idle positon..it doesnt vibrate when driving

2003 Toyota Corolla S

-

Maintenance & Repair
My 2007 Toyota Corolla makes a "clunking" sound the FIRST time I put it in drive. Won't do it again until I put it in reverse. Also, will make the noise while accelerating slowly around a turn. 1 Answer

My 2007 Toyota Corolla makes a "clunking" sound the FIRST time I put it in drive. Won't do it again until I put it in reverse. It will do it if I alternate DRIVE to REVERSE. Also, will make the noi...

2007 Toyota Corolla CE

-

Maintenance & Repair
1996 corolla starts fine,when i press the gas peddle down it cuts off. Why? 1 Answer

I can start out in low gear and slowly shift into drive and it will run fine. I stop turn off the engine a few minutes get back in it starts fine but when I pull out in traffic I can't step on the g...

1996 Toyota Corolla Base

-

Maintenance & Repair
I changed the compression rings in my engine, also changed my faulty carberator, (installed a used), now my car have a very high rev when it starts and the rev wont go away even if I kick the gas. 1 Answer

I have a Toyota Corolla AE 101, 1994 model with a 4A engine (using Carberator). When I go a few miles, the car would cutting off like it don't have any gas (but have). The compression rings and carb...

1994 Toyota Corolla

-

Maintenance & Repair

Used Toyota Camry

47 Great Deals out of 866 listings starting at $2,490

Used Honda Civic

240 Great Deals out of 3,514 listings starting at $1,440

Used Honda Accord

42 Great Deals out of 891 listings starting at $3,495

Used Nissan Sentra

67 Great Deals out of 1,706 listings starting at $1,795

Used Toyota 4Runner

14 Great Deals out of 358 listings starting at $12,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Car starts fine, but when put in drive or reverse the car won't move and when I press the gas a screeching noise will come and will jerk

1 Answer

Your Answer:

Shortcuts

Search Toyota Corolla Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

Car starts fine, but when put in drive or reverse the car won't move and when I press the gas a screeching noise will come and will jerk

1 Answer

Your Answer:

Related Questions