oil pressure reads 65 psi after key is turn on and still reads 65 psi after engine is running.
changed oil sending unit, no help.
Asked by captbill0747 Nov 26, 2014 at 08:09 AM about the 1998 Dodge RAM 2500 Laramie SLT Club Cab LB RWD
Question type: Maintenance & Repair
changed oil sending unit, no help.
changed oil sending unit, no help.
1998 Dodge RAM 2500 Laramie SLT Club Cab LB RWD
-
Maintenance & Repair
oil cluster reads zero,,,,emgine oil level is good
2010 Dodge RAM 2500 Laramie Crew Cab 4WD
-
Maintenance & Repair
We already changed the oil sending unit on the side of the block and we have already done a manual oil pressure test on the top of the filter and we got a good reading, we are getting oil to top end...
Dodge RAM 2500
-
Maintenance & Repair
The engine takes a few seconds to shut off after key is removed. Does this sporadically. Twice it has taken more than a minute to shut off. What would cause this?
1998 Dodge RAM 2500 ST LB 4WD
-
Maintenance & Repair
Turned truck off and about 2 hours later, tried to start and the engine turned over, but would not fire up. I checked to make sure it had fuel at the injectors and it did. Are the injectors controll...
2007 Dodge RAM 2500 SLT Mega Cab 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.