Chevrolet Impala Questions Maintenance & Repair
Wheres The Fuel Pump Kill Switch
I tryna find out where the fuel pump kill switch is located and what it may look like in my 06 impala
My Car Wont Start
I have a 06 impala lt im tryna make a brief as possible i ran out of gas to trying to get to the store got the gas ok went the where i was tryna go went to ger back in the car it would not start i...
2009 Chevy Impala Ls
It's bout cooling fans on more then usuall... when I'm driving cooling fans are on but at a stop sign or stop light they go off .car shows no sign of overheating ... .. I checked under the hood for...
I Just Had My Transmission Rebuilt On My 2001 Chevy Impala But Now It Wont ...
Car started just fine before transmission rebuild but now with rebuilt tranny in it wont start.
Car Over Heats And Idles
I have a 3400 2003 chevy Impala and it overheats within 5-10 minutes. I have changed the thermostat, water pump, hoses, radiator is only a year old, belt is new along with the idle pulley has coola...
Rpms Fluctuating, Struggle Accelerating Impala
Hey, i have a 2006 impala and lately I've been having a lottt of trouble getting past 20mph. Today though, my car wouldn't go past 40, only getting to 60 when I would go downhill. The rpms fluctua...
2010 Chevy Impala Passenger Side Blows Heat When Temperature Is Set To Cool...
Any suggestions? I'm starting to hate this car.
Help With 96 Ss Impala
my car loses power when I first pull off its like it cuts off then comes back on. it runs fine for about an hr with starting and stopping then it cuts off I have to wait for about 30 mins then it w...
2010 Chevy Impala Making Clicking Noise Behind Glove Box
Making clicking noise behind glove box
Heat
Heat on driver side is not working.
Passenger Headlight
My passenger headlight is not working, but my brights and signal lights/hazards work. Do I need to replace the whole headlight or can i just replace the low beam bulb to see if that fixes the prob...
Drive Cycle
I reset the ODB2 after a repair, now after 20p miles driven in varying conditions it syill shows the catalyst and ERG monitors still showing "not ready". What do I need to do to help this?
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.