Ford Bantam Questions Maintenance & Repair
Tatatata Sound In Engine And Jerking At Certain Speeds
Ford Bantam 1.6ixl 2006 model. Recently overhauled. Running reasonably well before engine overhaul. But now has a serious jerking problem especially at 90kph upwards. secondly, the car has a strange...
How Do I Remove The Sump Off A 2006 1.8i Diesel Ford Bantam
all bolts have bee removed te sump is loose and moves around but its as if something is keeping it from coming down.
I Have A Ford Bantam 2002 I Cant Seem To Get My Braks Fuction Right Every ...
Ive replaced master celinder brake pads brake discs and fleud please help
Hi All! My Ford Bantam 2003 Model 1,6i XLE Rocam Engine Is Overheating Afte...
My ford bantam 2003 model 1,6i XLE rocam engine is overheating after few minutes after I started.Fan tested and is functioning well. When I switch on the aircon the fan works fine & when it goes to re...
2010 WIPER RELAY,WHERE IS IT?
NEED TO FIND THE RELAY,THE WIPERS STOPPED WORKING
I Have Ford Bantam 1.3i 2007, While Driving The Heater Just Comes On Whethe...
I have Ford Bantam 1.3i 2007, while driving the heater just comes on whether the AC is on or not, causing heat in the vehicle. pls. help
Ford Bantam Brakes
I wondered if i can change my 2011 bantam disk brakes on my own.will i have to bleed the braking system or can i just remove it and fit the new ones?bcoz if i drive normally i have almost no brake...
I Have Problem I Have Changed Oil Pump But Oil Light Still Flashes And Engi...
bantam rocam engine noise I have replaced oil pump but it has noise when Idling or driving
Ford Bantam Starting Problems
Hi! I have a 1.3 bantam 2007 model, it only starts when the engine is cold. Ford mechanic tells me to replace the throttle body, solenoid and the starter motor. Could that be the problem?
Ford Bantam 2010 Heating Problem
Hi can someone please help me. My bakkie all out of the blue starting to heat up. My husband bought a new Waterpump as this was what the guy at Spares shop told him to get - no luck it is still heat...
I Removed My Plugwires A Replaced Them Wrong Back.
Ford bantam 2006 1.3i
Ford Bantam Bakkie Don't Want To Start
My ford bantam bakkie do not want to start at all. No lights going on as well as the lights on the dashboard. Battery working. No sound when turning the key.
2008 GENERATOR
2008 Ford bantam charging rate varies from 11.5 to occasionally 13 volts. Could this be fault in Generator please?
No Brakes
no brake flued coming out the right rear brake nipple after bleeding
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.