Ford Bantam Questions Maintenance & Repair
Noise In Engine
when I accelerate in any gear too hard, I get a kluging sound, until I relax on pedal. Change CV's both sides. still have problem. Sound seems to come from where left drive shaft goes into gearbox/...
Motor Not Turning Over
After replacing the distrubitor cables and cleaning all the spark plugs the enjin won't turn over or start
Turnning Steering It Switches Off
My bantam does not want to start normally I must accelerate and turning steering it switches off
Fueltank Capacity
Hi I just bought a ford bantam 2010 1.6 XLT fuel tank is 54L but I can only throw in 37L then it shows on meter the tank is full what can be the problem.
What Causes My Ford Bantam To Have No Power When Going Uphill?
sensers for power
Clutch Cable
how do I adjust the clutch cable on my 1990 ford bantam
My Bantam Does Not Want To Run
I have a 2009 bantam it starts but the moment that you push down on the gas it want to stall.what can be the problem please help
Overheating
Hi i have a 2006 ford bantam rocam. I had to replace thermostat housing and heater control valve. After i had replaced both the car would run fine on the highway for 80 kms to my place of work. On...
Bantam Rocam Crank And Start But No Idle
Hi. My Bantam has no engine warning light witch ignition switch-on. It cranks, start but wont idle unless I keep the pedal slightly presses to let air into the throttle body. DTC shows Engine temp sen...
2009 Ford Bantam Instrument Cluster
Hi. My bakkie keep in blowing the instrument cluster fuse (2ND fuse in fuse box). after replacing the fuse the instrument cluster will work for a long time And then suddenly everything dies except...
Help
Misfire Hi I have a rocam 1.6 2013 it starts and idles nicely but when I drive it misfires and hold back almost as if the engine wants to cut off...
Rocam Engine Sudden Cutoffs
ave a 2007 Ford Bantam Rocam engine, the car starts ok, idle for about 2minutes or more and thereafter suddenly cuts off. I've replaced the coil pack (non-genuine) and leads but still faced with t...
Knock Sensor Ford Bantam
Hi I'm putting a spitronics PCM management on my 1.3 ford bantam rocam. The diagram requirements is tdc sensor power, tdc sensor signal. Do I connect it to my knock sensor or do I go for the cam...
Fuel Consumption Of My Ford Bantam
Hi Guys, my Ford Bantam 1.3 rocam consume petrol like a camel drinking after a long journey, what could be the problem, I had replaced the oxygen sensors after the mechanic diagnostics
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.