Ford Probe Questions Maintenance & Repair
91 Ford Probe Won't Start From The Key.
For a couple of years, I just had to wiggle it a bit and it would start. About a month ago, that stopped working. Battery, plugs and wires seem fine. The starter and alternator have been replaced in...
How To Fix A 1989 Ford Probe It Quits After 20 Mins
it starts fine then after 20min it quits but restarts again and quits again
Where Would I Fine The Fuel Relay On My Ford Probe 91 3.0 LX Will Not Start...
checked pretty much ever thing out, shut car off would not start.
Why Want My Ford Probe Start?
probe ran great pulled in the driveway shut it off, went out the next morning to go to work and the car want start. I have checked pip,coil timing new belt installed a month ago, I have checked the fu...
95 PROBE GT
i asked the question earlier about having a modified 95 probe gt that has the klze motor but has the external coil the distributor has a mitsubishi symbol on it and i cant find a cap or if there is ...
I Have A 95 Probe Gt With A Modified Motor
is there a way to change back to electronic distributor? the one someone put in is from a mazda with the external coil and i cant find a cap for it
My 93 Probe Will Not Start When I Push In The Clutch,i Have Replaced The St...
car won't start when i push in the clutch, i am thinking when the old clutch master cylinder was leaking fluid may have gotten in to the clutch position switch, any ideas?
How Do You Put In A Ford Probe Manual Transmission?
It's hard to get in and I've already used the alignment tool and made sure that all the gears weren't getting boogered up, the pilot bearing is good, every thing seems right... It's just not going.
Can I Remove The A/C/ Compressor And Not Replace It?
1993 Probe 2.0 4-cyl with A/C. Compressor needs replacing. If I just remove it, are the other components in the same position as in the non-A/C model? Can I buy the standard non-a/c belt, install i...
Why Is My 90 Ford Probe Making A Clunking Sound When I Shift, Manual Transm...
When shifting gears, hear a clunking sound, 90 Ford Probe 4 cylinder front wheel drive.
How Do I Replace Wheel Bearings And Front Hub On 1990 Ford Probe?
I have to replace wheel bearing and front hub on mt 1990 frobe probe maybe drivers side axle? g
Dont Start Never Again
I was on highway my car was perfect, very good shape. I v stopped by rest area for 10 minutes. I v turned the key, engine turned but didnt start , we have boosted but didnt start . So, my Probe hav...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.