Jaguar Questions Maintenance & Repair
Surging
Hi, I wonder if you could help me, I have a V12 XJS, it starts OK and runs on all 12 cylinders but when it is hot it surges, from 750 rpm to 1400 rpm. I tuck the air filters out and the left bank is s...
Where Is The IAI Or The IAT At On A 02 Xj8 Vanden Plas
Has pcode 1111 and saw if you clean this sensor it will run right... HELP!!!!
Are There Parts Source Recommendations?
Bonnet, grill, headlights.
Transmission Fluid
Can the wrong fluid cause a P1722 code?
Where Can I Get A Repair Manual For 1998 XJ8 Jaquar VandenPlas.
failsafe engine mode light (amber) comes on, car runs good. Trying to find a repair manual for my make & model with no luck.
Check Engine Light And DSC Fault Light Is On.
My check engine light and DSC Fault is on. It also says that cruise control is not available. And to add on top of that it stalls and the engine turns off. Please Help!
Faulty Indicator / Wiring Affecting Rear Indicators
When I put indicator on to signal left turn, both rear indicators flash at te same time.
Hood Latch Will Not Release On Passenger Side, Cable Off. 1999 Jaguar Xj8
tried to open hood and drivers side popped up but not passenger side. found cable off on passenger side. how can i get in to open hood when cable is off/broken at latch on passenger side. thank you
Sterring Is Stiff
Sterring gets stiff while driving turn car off and its back to normal for a while and stiffings up again
No Power To The Car
My friend has a 2002 jaguar x-type and when I put the key in and attempt to start it, no power gets to anything in the car. I mean, i'm no mechanic but when you turn the key to accessory the radio sho...
2003 Jaguar X-type 3.0 Manual Transmission Problem
clutch was changed 5000 miles ago and while driving down hwy car lost power. engine runs fine and can shift through gears fine but it won't go forward or reverse. slight whining sound while in gear an...
Codes P0171 & P0174 (Too Lean Bank 1 & Too Lean Bank 2)
I have checked all vacuum lines, sprayed carb cleaner around MAP sensor, Intake manifold gaskets, between throttle body and manifold and around all vacuum points. All are tight. I've cleaned the MAF s...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.