Mazda 626 Questions Maintenance & Repair
Turn Signal Activating Cruise
Just finished doing some work on my car, and after putting everything back in I noticed that when using my turn signal it activates my cruise along with it. On top of that it messes with my gauges, ...
Hi I Have A 98 Mazda 626 4 Cylinder And I Want To Know If I Can Swap Motors...
i can't seem to find a 4 cylinder motor within 100 miles. the guy who's working on it needs a motor but all we can find are v6.
My Mazda 626 4 Cyl MT Has Leaking Water Down From Beneath The Transmission ...
Mazda 626 99 model 1.8L MT -water leaking from beneath the transmission?
How Do I Locate And Change Transmission Filter In My 2001 Mazda 626 Lx 4cyl...
its a 14bolt transmission pan the car cranks and runs but in park or neutral revs only to 4000rpms before bogging off but in any other gear it revs all the way but doesn't drive like its stuck in ne...
Can I Swap An Engine From A 1997 Mazda 626 Into A 1999 Mazda 626?
I have a 1999 Mazda 626 that's 2.0L 4 cyl, would it be possible to put an engine from a 1997 Mazda 626 2.0L 4 cyl?
Wondering If Its Thw Water Pump Or Thermestat
Over the last few weeks my car has started running alittle hot maybe once or twicw but as soon as I stop it goes back down to temperature and wont do it agaon I have to almost put water in it eve...
ON/OFF Light Blink Onmy Instrumental Alert Panel Where Often On On My Long ...
The "OD/OFF" light start blinking on my 1997 Mazda626 now on a long drive. I have my transmission rebuilt in2009 at15000 mileages current OD is 19000miles. Its' goes off after I shut rest it a...
I Have A 200 Mazda 626 Just Rebuilt The Trans Now If I Put The Shifter In L...
i got the care with the trans out of it i rebuilt it know it will pull in low and revers but it will not pull ot all if the shifter is in drive or 2nd there is not any codes in it and i dont think it...
My Car Is Having Trouble Starting. When It Does Get Going, It Revs High Fo...
my car is having trouble starting. when it does get going, it revs high for a bit and sometime even revs up & down on it's own. this happens until it gets going for a while. any ideas?
I Have A 98 Mazda 626 4cyl With A 2002 Motor In It. It Cranks And Run Fine ...
I've change mas, iac, fuel pump and fuel filter, injector rail and injectors, throttle body, egr, fuel regulator, coil pack, wires and plugs. Checked timing and compression on all cyl is good, cat...
How Do I Set The Timing
The water pump broke we got it fixed and was putting it back together when the timing pulley slipped and knocked out of time and im trying to figure out how to put it back in time. Also will the spark...
2000 626 2.0 High Rpm Wen Started Then Gets Worm To Low Of Rpm
when i start the car the car rpm's are over 1200 then when the car is at running temp they are about 650 and running ruph.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.