Mazda Questions Maintenance & Repair
I Am Taking Apart To Rebuild The Carburetor I Noticed In The Base Of The Ca...
I am taking apart to Rebuild the carburetor I noticed in The base of the carburetorI or Manifolds Intake I see a butterfly valve.I suck air through the vacuum valve bat Doesn't close.What do you thi...
Over Heated Car
I changed my radiator but my car is still running out is it necessary to change the thermostat as well ?
Does My Car Have Non Interference If The Timing Belt Breaks?
the timing belt broke as we were driving and the car shut down, does it have non interference so the valves will not be damaged?
ABS Brakes And Warning Light
I was told that my ABS brakes were shot and needed to be replaced, yet the ABS warning light is not lit. The ABS warning light comes on when I turn the car on but goes off immediately like the rest...
Where Is The Rateator
were is the rateator
Mazda3
in the mid of driving the car shuts off, radio and wheel locks up than back on while driving
Check Engine & Traction Control Lights On When It Rains
Check engine & traction control lights come on when it rains. Car will only dd 10 mph. Runs fine when it dries out.
Mazda6 Engine Swap
Can u out 04 mazda 6 engine in 06 model if u change cam?
Car Grinds When You Put It In Gear
Hard to get it in gear when shifting
Air Filter Removal?
I have my dash apart replacing the stereo and I found a filter behind the glove box. I'm assuming it's an air filter. It falls apart to the touch. I can't find any information on it, so here i am. It ...
Mazda Tribute Want Start
i have problem with my mazda tribute it was misst fire cilinder 3 and i change all spurkplugs and coils new all 6 of them but now want start at all i change cam shaft sensor crank sensor wont satrt a...
Control Arms On A Mazda
Does changing the control arms on a mazda affect the universal joints or drive shaft? Mine was changed by the dealer and since then my u joints or something is skipping and/or vibrating badly.
Damaged Hood
what do I do for a badly damaged 2018 Mazda 6 hood. There seems none are available in USA and after market parts not yet available. The damage is too severe to be fixed (according to bodyshop) an...
1992 Mazda B2200
Can I switch my 2.2l carbureted motor to a 2.2l fl? Also does anyone know a leveling kit for the 92 Mazda b2200?
Not Sure
My 2007 mazda 3 wont drive in drive or reverse it sounds like a chain running on nothing
Valve Adj.
2002 Mazda b2300 ?mech. Or hyd. Valves ??
1990 B2200 Mazda PU Sudden Cut Out
My 1990 B2200 Mazda PU with AT and FI, has a leaking Water pump seal, also needs a new radiator. Before I could order new ones, I drove it (with a full radiator), less than 1/8 mile to clubhous...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.