Plymouth Questions Maintenance & Repair
The Ring That Holds My 92 Plymoth Aclaim Is Wielded On How Can I Fix It To ...
the rig that holds the fuel pump in is wielded on is there anyway to get it off without breaking it? i cant find a replacement for the ring
My Van Quit While Running But Did That On Occasion. The Last Time It Done I...
We have changed ignition switch, ICM, starter relay, fuel relay, starter, and the neutral switch. We have checked the to see if power was getting to starter and other parts and there is power. We ha...
Waterpump
How do I get the water pump off my,1993 Plymouth Voyagerr
Why Isn't My Fuel Pump Getting Power?
Prior to doing any of the things listed below I removed the instrument cluster and re-soldered the connector solder points. The cluster is functioning properly. The 3.3L engine turns over but will ...
Car Repair
What causes water to come out your exhaust while you're filling up your radiator and it's not just a little it's a lot
No Spark
New camshaft sensor and crank shaft sensor no spark no start
1962 Valiant Signet 200
Will a signet 200 body fit any newer model frames with newer drive train and braking
1974 Plymouth Fury Stalling Issues.
I have a 1974 plymouth fury, has a 360 small block, holley 600cfm 4 barrel, air gap intake, shorty headers and flow master exhaust. I purchased this recently and it ran great, drove it 2 hours home...
2000 Plymouth Neon
I have a 2000 plymouth neon with a 4th cylinder misfire. So far I have changed valve cover, plug wires as well as plug. I have checked compression 3rd was a little off but 4th cylinder was way low...
Which Belt Drives The Waterpump On My 1998 3.0 Liter Voyager Base?
I need to replace the water pump on my 1998 Plymouth Voyager Base. It has the 3.0 liter with AC
What Causes All This
loose power transmission won shift lights flicker runs the battery dead door locks lock and un lock constantly little jump and cars fine for a mile or two then same battery seems dead wont start til...
My Car Wont Start.
I have a 2000 Plymouth Neon. It was been sitting for a couple years without being started. I just put gas in it and put a new battery in it the engine is trying to turn over but it wont start. It did ...
Blowing Fuses
My 99 Plymouth voyager just started blowing fuses today. I've replaced it several times and as soon as I start it the fuse blows again and it knocks out blinkers, my heat ect. What can cause this?...
1998 Plymouth Voyager Went Into Limp Mode.
Replaced input and output sensors. Check engine light is off. But keeps going into limp mode. Code i got was p0700 and p1782 and 4 others that mean it's my gears i guess. I really need help solving...
Replaced The Timing Tensioner Pulley And Timing Idler Pulley, Now My Engine...
I had a clacking noise in the timing belt cover. Turns out the timing tensioner ate itself. I replaced the timing belt, timing tensioner pulley and timing idler pulley. I made sure the cams and crank ...
Front End Noise And Scared To Drive
Front end making noise when turning both directions almost feels as if the bearings but worse.
Replacing Water Hose In Back Of Water Pump
need to replace small hose coming out of thermostat housing... question is do i have to take off the entire manifold just to get to it...there's just not enough room otherwise???? thank u
96 Plymouth Grand Voyager Random Loss Of Accel. With Oil Light, Loss Of Pow...
I brought my 1996 Grand Voyager (3.3L, 195k miles) in to get a laundry list of things done prior to a lot of driving this summer. I had the lower intake and valve covers, PCV valve, fuel filter, f...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.