2001 vw passat mechanic doesnt know why engine loops wont stay running

505

Asked by Dan Mar 28, 2017 at 08:50 PM about the 2001 Volkswagen Passat GLX

Question type: Maintenance & Repair

ok here is whats going on. my first Passat 2001 2.8 v6. bought it knowing it had overheating problem. in excellent condition, ran great, what a great deal I thought. well I drove it 1 day, that was before xmas. this is not my first time working on a car. I removed everything needed to replace waterpump. didn't remove the crank pulley and timing belt left that on so I didn't mess with timing and careful not to move camshafts. put it all back together. it wouldn't start. during the work I removed battery (didn't know not to remove battery)it was out of car for about 2 weeks as I worked in spare time. when I had it back together at one point I set off alarm system (the original radio has been replaced). I don't have the remote control key only the chip key. used obdII scanner and the only thing that came up was throttle position sensor and mass air flow well I eventually got a chiltons vw/audi manual. read it went back and re did the timing placement (which came out correct on marks that I had made) and made sure elec plugs for everything else was correctly done, including somethings that I didn't even touch that were not correctly in place. from there I sent it to a vw/audi mech to have engine parameters reinstalled. after a week he said the ECM info would only give throttle position sensor low & high codes. that ECM would not reset so he could set parameters. he could erase codes but that's it. also 5 & 6 cyl were at 82 and 90 psi respectively. he didn't know what was wrong with it and had spent 10-12 hours on car. installed a new battery as well. I have checked with compression tester myself and got same readings. 1-4 cyl are at 120 psi. from past engines I know the engine should start and run, yet only will start for 5-10 seconds looping and die. I checked 4,5 & 6 cyl spark wires and only have 2000 ohms, wires are cracked, and one is badly corroded at the ignition coil side. I know that wires need to be replaced. just could that be the reason it wont start. frustrated after buying car and cant get it running.

5 Answers

15

Hmmm you might need to get your throttle body reprogramed... when you disconnect the battery the throttle on these vehicles tend to loose the position they are suppose to be on

505

ok. is it possible to connect my scan tool to another Passat same year etc... and download the info from that one on scanner and then upload the parameters to my Passat. trying to avoid even more spending than I already have lost and losing as well. I have decided to pull heads and replace gaskets. used a camera scope and looked inside through park plug hole and it clearly looks like blown head gasket. more so is that #5 and 6 both have low compression. cant get them to go above 80 psi after about 5-6 revs of engine. 1-4 cyl easily hit 120 psi by 2 rev. plus there are no marks on valves or piston head to indicate a collision.

15

Try a wet compression test. This should help you determine if you have bad piston rings, valve or cylinder wall.. take spark plug off your cylinder with low compression add oil, put your compression tester back on. If your compression rises it means you have bad piston rings. If no raise you have bad intake or exhaust valves.

15

Your best bet would be to take it to the dealer for a diagnostic it will run you about anywhere from $140-$180 make sure to explain everything you've done to the vehicle and what's going on.

505

willy, I have been able to get to the point where I have had it running on several occasions for just about 30 seconds. each time discovering something I had forgot. this last time it was transmission fluid line. I have purchased a VAG 401 scan tool which has been a huge help. now I am at the point where I have no codes being sent and I am very confident that I have no other issues. yet I still cant get it started. in the morning it will start up for 30 seconds, then die and not start up again. it will crank just fine. I have spark, fuses and relays are good, no codes, plenty of battery, checked the ignition switch, park/neutral switch, pulled fuel rail and checked the leads to injectors and injectors, I even added more fuel as the car has been sitting since before last xmas. the only thing I think could be wrong with it is the filter or fuel pump, yet its getting fuel to rail. so what else could it be.

Your Answer:

Passat

Looking for a Used Passat in your area?

CarGurus has 402 nationwide Passat listings starting at $4,700.

Postal Code:

CarGurus Experts

  • #1
    Deathjam4
    Reputation
    4,470
  • #2
    Chrisand Edwards
    Reputation
    2,660
  • #3
    tenspeed
    Reputation
    2,420
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Volkswagen Jetta
82 Great Deals out of 1,896 listings starting at $995
Used Honda Accord
40 Great Deals out of 910 listings starting at $1,599
Used Toyota Camry
52 Great Deals out of 985 listings starting at $2,212
Used Honda Civic
180 Great Deals out of 3,705 listings starting at $1,995
Used Nissan Altima
22 Great Deals out of 716 listings starting at $1,400
Used Volkswagen Jetta GLI
3 Great Deals out of 383 listings starting at $5,499
Used Chevrolet Malibu
50 Great Deals out of 1,139 listings starting at $1,295
Used Audi A4
43 Great Deals out of 698 listings starting at $4,750
Used Jeep Grand Cherokee
109 Great Deals out of 3,238 listings starting at $4,995
Used Volkswagen Golf
26 Great Deals out of 444 listings starting at $3,987
Used Audi A6
5 Great Deals out of 117 listings starting at $3,950

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.