Chevrolet Questions Any type
Car Turns Over But Won't Start
Bought a new battery put oil in the car and gas still won't start
Car Cut Off While Running, Now Won't Start And Souds Different?
I was warming vehicle in preparation to leave work, when i got in vehicle engine was not running and now won't start and sounds different when turning over. Drains battery quickly
Oil Type For 1973 Chevelle Malibu
Recently bought a '73 Chevelle and am needing to change the oil, but I can't find any recommendations for oil grade on anything that old. What might you all recommend?
Rough Idle
My 4.3 vortec is idling rough and jerking until I get it up to speed, low compression, I changed the plugs and they were dry. Check engine light code said misfire on cylinder 5...my daughters moth...
2014 Chevy Camaro SS Rims On My 2002 Chevy S10
I have a 2002 Chevy S10 rwd base model. I want to put some 2014 Chevy Camaro SS rims on my truck. Can anyone tell me what thickness wheel adapters I need to use in order to accomplish this?
Wont Go In Drive Or Reverse..
My 2010 chevy equinox wont go in drive or reverse. When i cut the truck off and start it again it will drive on for a minute then it stalls again
Will A 96 Chevy 8' Camper Shell With 8'bed On A 2004 Chevy 8' Chevy Bed?
That's a 8ft 96 Chevy truck bed camper shell fit a 04 Chevy 8ft bed
2012 Suburban
I have a Suburban that needs a new engine. It has 158,000 miles on it and is in very good shape. All leather, dvd entertainment system, 4 wheel drive. What do you think we could sell it for as is?
P0122 / P1122 DTC Diagnostic Trouble Codes
This may not be completely relevant to original post, but DTC P0122 haunted me for months on my Canadian 2005 Chev Optra5 (sister car is Suzuki Reno / Forenza in USA), I would switch out sensors, th...
Obd
I can't get any reading from my on board diagnostic
Over Full Oil??
Ok so I changed the oil in my 86 scottsdale with 5.7l in it. Changed the filter as well let it drain forever an blew what I could out by blowing in the vavle cover. I 5 quarts in it and drove it fo...
Too Much Pressure In The Clutch Pedal
I just replaced the clutch master and slave cylinders on my 1989 Chevy 1500. The bleeding went well, but now I have too much pressure in the pedal. How can I fix this?
97 Chevy S10
Replaced head gasket, injectors, valve guide seals, spark plugs, wires and coils all new, truck will not idle smooth. Smooths out at higher rpm but still rough idle, any idea what to look at?
99 Chevy K1500 5.7 No Start After Below Zero Temp
Ok I've always been the go to guy when crap breaks and I've always found the issue. Well today was where that ol saying came true. There's a first time for everything. So here goes. I bought this ...
Right Front Lower Control Arm Bolt
can not get the bolt out is there a hole or special tool to get a hold of the nut
No Spark
I have a 95 Chevy Silverado 5.7 I have changed all plugs and wires new cap and rotor button new ignition coil but there is no spark to the ignition coil
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.