Ford Falcon Questions Maintenance & Repair
1963 Ford Falcon
The bolts on the manifold studs are loose but it will not tighten
4 Speed Trans.
could you tell me what kind of 4 seed trans would fit in my ford comet 260 v8
Rims Tires
I have a1963 ford falcon two door 6 cylinder with13" tires 4lugs .Looking for slightly bigger tires 14" 15 " would rims off of a 1984 ford focus would they fit or another ford car
Constant Power
why do i have constant power to my interrior light and my ignition light even when the keys have been removed from the ignition
Battery Not Charging
My battery in not being charged by the generator. I've never worked with a generator and/or volt regulator. What is the best way to test all of the components to narrow down the problem?
Transmission Fluid Type F
Just wondering if type f transmission fluid m2c33- f or g would be ok to use in a 1963 ford falcon 6 clyinder 170
Bleeding The Brakes
Need to change the brake light switch that is connected to the master cylinder do i need to bleed the braker afterwards
How Can I Get My Turn Signal To Cancel On My 1963 Ford Falcon Futura?
I have replaced the turn signal switch with the canceling cam built into it. I have also replaced the steering wheel with a NOS steering wheel/horn ring. However the steering wheel does not seem to ...
How Can I Get My Turn Signal To Cancel On My 1963 Ford Falcon Futura?
I have replaced the turn signal switch with the canceling cam built into it. I have also replaced the steering wheel with a NOS steering wheel/horn ring. However the steering wheel does not seem to ...
Door Lock Cylinder
I need some help in changing my door lock cylinder on my 61 ford falcon. Thank you
My Car Has New Spark Plugs, And No Other Known Issues But When I Pt My Foot...
has new spark plugs, runs beautiful usually and still does once at speed i want to be at or i am not giving way and taking off.
Horn Only Works When I Push The Clutch Down.
Any suggestions will help. Thanks
Car Starts But Idles Rough Then Dies Shortly
I don't know too much about Cars but it has a 170 inline 6. it also has an auto lite 1100 recently rebuilt carb. When started it sounds just terrible but it'll run on its own, but will die within t...
What Size Screws Are Used To Hold The Condenser And Points In Place In My 1...
rebuilding my distributor and the screws for the points and condenser are missing. need to know what size and thread,etc.
63 Ford Falcon Front Wheel Bearing Replacement
I have a 63 ford falcon futura with a bad drivers front side wheel bearing. Ive worked on cars before but have never done a bearing could someone help me find out exactly which bearing I need to b...
Door Latch Retaining Clip
the rod from the outside door handle is disconnected from the door latch retaining clip. the old one still in place . does this mean that I need to replace door latch retaining clip.
My Turn Signals
my turn signals are not flashing front and back even on my dash board is it a fuse?
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.