Ford Falcon Questions Maintenance & Repair
1964 Ford Falcon Automatic Transmission Shifting Hard
I have a 1964, Ford Falcon Futura with 260 V8 and 2 speed Fordomatic Transmission. I let the car sit for a couple years without driving it, which was a huge mistake. The motor is running rough and t...
Window Crank Knob Removal
I have a 63 Sprint, I took the window crank off to replace the white knob on the handle, but I cannot figure out how to get the little white knob off.
Rear Seat Removal For A 63 Ford Falcon
Ok i was able to get front bench seat out now to figure out the removal of the back seat where do i begin on this project? Thànk you in advance!!
Manual Steering
Why is my manual steering 1965 Ford Falcon so hard to steer?
I Have A 61 Ford Falcon 170cc Engine How Can I Tell Now The Tank Is Out How...
My gas tank was removed and rust was found. Once taken to have it boiled out at local radiator shop, I was informed and saw rust throughout. Now I believe I have the 16 gal but not sure.
Oil Sump Gasket
do i need to take transmission box out to change sump gasket
Install A Rear 1/4 Window In A 1963 Ford Falcon Convertible
I cant seem to find the right combination to install a rear 1/4 window in a 63 falcon convertible. I have tried every single combination to install this window. Very frustrated HELP!!!
Bogging On One Barrel
Slow start of line to much pedal black smoke
Starting Car In Oark NSS
My 1961 falcon turns over in nuetral only. Some say NSS. Others say slop in the steering column.
1961 Ford Falcon
My falcons seem to always needs some starting fluid or it turns over awhile before it starts up. Can someone help me with what's going on here? Is it a bad starter solenoid or starter , carb, or wh...
Automatic Transmission
It started with a buzzing sound when driving or a air sucking type noise,but when it warmed up it went away,after a while there was a lag before reverse or drive would engage(which got worse over ...
Different Tyres Sizes On The Front Axle On A Rwd.
I had two new 17 tyres placed both on the passenger side of my car at Bridgestone, I also have a spare wheel on the drivers side front axle which is 16 inch. Should they have put the new tyres on ...
Bench Seat Track
Would a bench seat track from 1965-68! Bench seat track would it fit a 1963 ford falcon bench seat tr
Donute Gasket
What are the steps for replacing a donut gasket do you loosen the brackets holding the exhaust pipe to the frame to give more slack
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.