Triumph TR6 Questions Maintenance & Repair

Engine Speed At Startup

Installed new distributor and rebuilt carburator and when i start the car, the engine runs well over 3000 RPM. What is causing this? What are possible solutions?

Could This Be An Ignition Switch ?

car will start and run with the key held between run and crank. if I let the key return to run the car will die

Motor

Are the TR6 engines sleeved and can one be sleeved?

TR6

car runs good for aprox 20miles then jerks and stops leave sitting for hour starts and runs good again?

Triumph Tr6 Acts Like Its Out Of Gas

I have 1974 triumph tr6 I drive for about 20 minutes and. It chokes and dies then it won't start ????

Triumph TR6 Replacing Sump Gasket

Can gasket be replaced with engine motor in place

Engine Wont Start After Sitting For 12 Months

Ha,ve spark at spark plugs.Fuel pump running,have fuel delivery to injector pump,have fuel at tank return.Have no fuel at injector line when winding over.HELP

Car Stops After Running About Ten Minutes.

My Triumph starts okay but after driving about ten minutes acts like it is out of gas & stalls. It will not re-start unless it sits for some length of time. It sat without being driven for about s...

1971 Triumph TR 6 Won't Start. Turns Over Good.

New points, plugs, plug wires, new rotor. I started it up and pushed in the clutch and it died out and won't restart, battery good and it turns over. anyone have any suggestions? The spark on the pl...

Car Runs Great When Cruising But Breaks Down Under Torque??

My Fuel And Temp Gauge Has Stopped Working Could It Be The Voltage Stablize...

What Gauge Wire Or Ampere S Used In Wiring Harness

I just had a short from a previous owners kluge for a replacement radio (he put in a new one and added a small fuse box) and burned the WR wire from ignition to power I need to replace that wire. ...

I'm Having Problems With A 1976 TR6 Restoration.

Back brakes: everything is new, shoes, adjusters, cylinders. I checked all parts and all part numbers. The only thing not new is the drums. I bead blasted them. Adjusters are turned all the way...

Poor Performance

My TR6 shows signs of poor performance as I shift through each gear when the RPM is between 2200 and 2400. In any gear with the RPM higher than 2400 performance is normal. The car has an electroni...

Brakes

pedal goes to the floor but fluid is fine.

Cylinder Repair

Dropped a valve on a TR6 2495cc, It destroyed the piston and gouged the cylinder. Can I replace or repair the cylinder sleve?