Chevrolet Questions Any type
Cannot Remove Camber Bushing On 1986 K10, Tried Penetrant And Shocking With...
shop says they need to remove front BJ at $600
Can Rear Seats From A 2005 Chevy Uplander Fit A 2008 Chevy Uplander
Are the rear seats from the 2005 Chevy Uplander compatible to a 2008 Chevy Uplander?
Key Stuck In Ignition
93 cavalier la key stuck
Stabilitrack Light And Service Pwer Steering Notification
I have a 2014 Chevrolet Equinox that both these things came on at the same time. Is it one problem or separate problems. How do I find out if I really need to take it to a mechanic or if its an eas...
No Spark To The Plugs
no spark to the plugs, new distributor,wires,coil, plugs
Trying To Get An Engine Swap
What other engine can I put in a 94 Chevy Caprice Classic without changing a lot of stuff
Looking For A Way Engine Swap
What engine swAp can I put in there without changing alot stuff
1997 Chevy C2500 With 5.7l Vortec Won't Start.
Replaced a very bad distributor, cap, roter, wires and plugs. Also old fuel filter, and fuel pressure regulator. Truck has over 267,000 miles and the above parts were all original. I have worked o...
Can I Put 2004 Parts On My 2008?
Can I use parts such as, both mirrors, the hood, and both tail lights All from a 2004 Chevy Trailblazer on my 2008 Chevy Trailblazer?
Can I Reattach The Clucth Fan Mount On My Waterpump?
After i replaced my waterpump the seal on one side didnt hold, and when it blew it popped the mounting pully off that i attache my clutch fan to. Can i fix this or do i need a new pump?
Waterpump 305 5.0 84 Chevy Custom Deluxe
After replacing my water pump the attachment housing that my clutch fan bolts onto my water pump came off. Can i reattach this with a special tool?
Power Steering Rack Compatability
is the power steering rack the on a 2000 base model Impala the same as one from a 2002 LS model ??
I Have A Question About My 4 Wheel Drive
My transfer case whenever I lock it in its sending power to my actuator and my actuator is pushing out but my differential is not locking in when the actuator is out I can easily push it back in b...
How Do I Hook Up My REM Wire For My Amp To The Ign
So I have a 2002 Chevy Trailblazer LTZ I want to know is how do I connect my REM wire for my aftermarket amplifier to my ignition so it'll turn on I just want to know how to do it maybe you can se...
2001 Monte Carlo SS Muffler Suggestions For More Bassy/louder Noise?
I have a 2001 Monte Carlo SS and I was wondering if there was a muffler that can make it sound more bassy/louder. The reason is that when I'm driving with my friend his car is louder than mine. I wa...
Why Is My Clutch Chattering?
I just installed a stage 2 clutch in my cobalt about 700 miles ago. Drove it without hitting boost for the first 500 for brake in. They didnt say to do the brake in but I did anyways. I was running...
92 Rs 25th Anniversary 3rd Gen Camaro 5 Spd
I have a 92 rs 25th anniversary 5spd 3.1 v6 3rd gen Camaro all original and wanna put 350 in will trans hold?
Intake Manifold Tuning Valve
i just replace my tuning valve and it keeps popping out. My car dies and sputters until its popped back in. But it wont stay in place. Is this because its faulty or something else?
2014 Equinox Driver Side Floor Soaked ?
floor soaked on driverside floor
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.