Ford Bantam Questions Maintenance & Repair

Ford Bantam 1.6 Cranks Does Not Start

i have a ford bantam 1.6 just cranks does not start.battery voltage 12.65v but when i jump start no problem for the whole day where is the problem please help

FORD BANTAM Overheating

I have a Ford bantam 20081.3 rocam which is now overheating, I took out something inside the return hose going to the radiator water bottle last month, I thought it was debris from fixing of radiator...

Ford Bantam Diesel Pump

what is the difference between the diesel pump of ford bantam 1.8 vs 1.4

Ford Bantam Rocam 1.3i Misfiring Issues

My ford bantam rocam 1.3i engine has recently been overhauled. Cylinder 2 spark plugs keeps dying. When I remove the spark plug, there seems to be oil on the thread of the spark plug and the plug is...

Oltanetar Conicting

I have new oltanetar but the old one was using one capole for egnishin but the the new one has 3 capoles haw to connect it is Ford bantam rocam 2007

Ford Rocam Bad Starting

Ford rocam 2009 not starting when cranking but starts when push started. Any ide ?

Ford Bantam 1.3 Rocam Weird Overheating Problem

Hi All, new to this forum, but this is now where I am forced to try and get some guidance on the issue I have. My Bantam has now stated with this weird overheating problem about 3 months ago. I woul...

My Ford Bantam 1.3 Rocam Don't Want To Start. Please Help.

Good day. I'm having a problem with my Ford Bantam 1.3 rocam. I've changed my head gaskets and replace my oil and oil filters and I've torque the head the nm's I should've. I ensemble everything a...

Ford Bantam Problems

I drive a ford bantam when the engine is hot it jerks and switches off then I must wait for 10 to 15mins then it drives again

Key Transceiver Loom Replacement And Reprogramming

After replacement of key transceiver loom do I have to reprogram the new transceiver.

Where To Find The Indicator Flasher Unit

Ford Bantam RPM Drops On Revv What Could Be The Problen

Hi i have a bantam rocam 1.3 off gear it its idling is not steady and when i revv it the RPMs just drop completely....please assist

2008 Ford Bantam Crank No Start

I have 2008 Ford Bantam rocam 1.3. It cranks but no start. It has an older computer box used in pre 2007 bantams. I have changed the flywheel to match the ecu as advised and used a 36-1 tooth fl...

Ford Bantam Rocam Engine . Crank No Start

Hi. I have a 2008 ford bantam rocam 1.3. It cranks and has fuel and spark but no start. I'm using a 1.6 ecu for pre 2007 bantams. I also changed the flywheel to match the ecu 36-1 teeth. Does the ...

Ford Bantum Rocam 1.3

My ford bantum rocam gives on but does not want to start or even crank the engine,what l noticed again the is a small red light near the watch that switches on when l turn on the car then off and ...

Ford Bantam 1.6i Xlt Rocam 2011

Kindly assist. I have ford bantam 1.6 xlt rocam 2011 model. It used to jerk while in motion when I accelarated. I was advised to change the coil; spark- plugs and fuel filter of which I did but there...

Why Is My Bantam Not Switches Off After Starting?

My bantam won't switch off After starting what can cause that?

Need Help With A 2008 Ford Rocam 1,3 That Is Hard To Start When Cold

Hi all i recently bought a non runner Bantam with high mileage and decided to completely overhaul the engine, now i am experiencing 2 problems, not sure if its related. Problem 1 the bakkie is hard...

Bantam 1.3 Rocam Feul Problem

My bantam doesn't start when it is warm, it also does not get feul at the injectors in front. We replaced the feul pump and the cranck sensor, but it still does the same? Any suggestions?

Why Is My Ford Bantam Not Gin In Gear

I have a 2006 Ford Bantam rocam,it does not want to go in gear when the car is on,the clutch is stiff like always.what can it be please